研究生: |
許馨文 |
---|---|
論文名稱: |
以三維足型資料建置客製化鞋楦 Construct Customized Shoe Last by Using 3-D Foot Scanning Data |
指導教授: |
王茂駿
Wang, Mao-Jiun J. |
口試委員: |
林志隆
郭建甫 |
學位類別: |
碩士 Master |
系所名稱: |
工學院 - 工業工程與工程管理學系 Department of Industrial Engineering and Engineering Management |
論文出版年: | 2012 |
畢業學年度: | 100 |
語文別: | 中文 |
論文頁數: | 77 |
中文關鍵詞: | 足型分類 、資料挖礦 、群集分析 、尺碼系統 、客製化 、變形 、鞋楦 |
外文關鍵詞: | foot type classification, data mining, cluster analysis, sizing system, customization, deformation, shoe last |
相關次數: | 點閱:2 下載:0 |
分享至: |
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報 |
本研究目的為蒐集台灣地區1033位18到30歲的男性與752位18到40歲的女性受試者之三維足型資料,進行足型分析,並提出一套足型分類尺碼系統,最後以足型分類尺碼系統中的代表足型為例,建置客製化鞋楦。
首先利用資料挖礦方法找出對於足型具有代表性之足部參數,分別為「足長」、「足寬直線」與「足弓高」,分別屬於長度、寬度與高度三個維度之相關尺寸,可對足型有更好的解釋程度;其次將國人的足型依性別各分成四種代表類型,並給予語意上的描述,男性為「低足弓窄短型」、「高足弓窄短型」、「高足弓寬長型」和「低足弓寬長型」,女性部分則為「高足弓寬長型」、「高足弓平均型」、「低足弓平均型」和「低足弓窄短型」;再者,以這些參數作為足型分類的依據,並結合實務生產情況,選擇適當的尺碼分類原則,建立一套有架構且符合國人的尺碼系統,藉以了解國人的足型差異,後續將本研究之足型資料庫樣本與分類尺碼系統進行疊合,在男女性之涵蓋率分別可達95.93%和92.02%。
在實務方面,提出一套鞋楦寬放與縮放機制,針對足型資料重複驗證,男女性之平均誤差值分別為10.91 mm與10.46 mm,可有效改善過去以等比例縮放所造成的合腳性問題;並利用電腦輔助設計軟體,將縮放機制實際應用於男性代表足型。並以本研究所提出之足型分類尺碼系統中的代表足型為例,實際製作出其客製化鞋楦,期望達到具有快速且高解釋程度之效,以期應用在大量客製化之鞋具製作。
The purpose of this study was to collect the foot dimensions of 1033 Taiwanese males and 752 females aged 18-40 years and to classify three-dimensional foot shapes. Foot type sizing system and a customized shoe last were built based on the results of the foot type classification and some practical considerations.
Principle component analysis was applied to obtain the important dimensions, including foot length, foot width and the arch height. The parameters belong to the length, width and height of the foot dimensions for better foot shape explanation. Clustering analysis was performed to identify four foot shapes including : narrow-short with low arch height, narrow-short with high arch height, wide-long with high arch height and wide-long with low arch height for males; wide-long with high arch height, average with high arch height, average with low arch height and narrow-short with low arch height for females. Moreover, we established a category sizing system to differentiate the foot shape of the people by gender.
In application, we proposed a shoe last design based on the foot shape of this study. Finally, the customized shoe last design is expected to achieve fast and high degree of mass customization of shoes with production.
參考文獻
1. 鞋技中心網站http://www.bestmotion.com/frthome.asp
2. 李毅帆(2008)。應用資料挖礦方法建立兒童足型鞋碼系統,國立清華大學碩士論文。
3. 林承哲(2002)。以三度空間腳型量測儀建立腳型尺碼分類系統,國立清華大學碩士論文。
4. 麥麗敏(譯)(2002)。Snell臨床解剖學。台北市:合記圖書出版社。(Snell, R., 1997)
5. 盧俊銘(2009)。利用三度空間掃描資料擷取人體尺寸與體型,國立清華大學博士論文。
6. 鄭豐聰(1998)。腳型尺碼資訊系統與鞋楦設計關係之研究,國立交通大學博士論文。
7. 曹文彬(2007)。客製化人體足部之鞋楦特徵設計之研究,東海大學碩士論文。
8. 趙文瑀(2010)。以足部三維形狀特徵參數建立足型分類尺碼系統,國立清華大學碩士論文。
9. 林宜婕(2011)。以三維足型尺寸建立足弓型態分類與應用,國立清華大學碩士論文。
10. 何青鄅(2006)。影響消費者選購名牌服飾之因素分析,中華大學碩士論文。
11. Adrian, K.C. (1991). American Last Making: Procedures, Scale Comparisons, Sizing and Grading Information, Basic Shell Layout, Bottom Equipment Standards, Published by the Shoe trades publishing Co., Arlington, MA, USA.
12. Ashizawa, K., Kumakura, C., Kusumoto, A. & Narasaki, S. (1997). Relative foot size and shape to general body size in Javanese, Filipinas and Japanese with special reference to habitual footwear types. Annuals of Human Biology,24(2), pp. 117-129.
13. Cheng, C.Y., Leung, S.F., Leung, K.L., Guo, X., Sher, A., & Mak, F.K.(1997). Change of Foot Size With Weightbearing; A Study of 2829 Children 3 to 18 Years of Age. Clinical Orthopaedics,342, pp. 123-131.
14. Cheng, F.T. & Perng, D.B. (1999). A systematic approach for developing a foot size information system for shoe last design. International Journal of Industrial Ergonomics, 25(2), pp.171-185.
15. Clarks, Ltd. Training Department (1989). Manual of shoe making. Training Department Clarks, UK
16. CNS 4800-S1093. (2000). 鞋之尺碼.
17. Gong, T., Fei, R., Lai, J. & Liang, G. (2010). Foot Shape Analysis of Adult Male in the China. Communications in Computer and Information Science, 106(1), pp. 1-7.
18. Hawes, M.R., Nachbauer, W., Sovak. D. & Nigg, B.M. (1992). Footprint parameters as a measure of arch height. Foot Ankle, 13(1), pp. 22-26.
19. Hong, Y., Wang, L., Xu, D.Q. & Li, J.X. (2011). Gender differences in foot shape: a study of Chinese young adults. Sports Biomechanics, 10(2), pp. 85-97.
20. ISO 9407. (1991). Shoe sizes-Mondopoint system of sizing and marking.
21. JIS S 5037. (1998). Sizing system for shoes.
22. Kaiser, H.F. (1960).The application of electronic computers to factor analysis. Educational & Psychological Measurement, 20(1), pp. 141-151.
23. Kalebota, N., Szirovicza, L., Tucaković-Mujagić, L. & Drenovac, M.(2003).The Structure of Body Measurements for the Determination of Shoe Sizing for Young Croatian Men. Coll. Antropol, 27(2), pp.635-643.
24. Kogler, G. F., Solomonidis, S. & Paul, J. (1996). Biomechanics of longitudinal arch support mechanisms in foot orthoses and their effect on plantar aponeurosis strain. Clinical Biomechanics, 11(5), pp. 243-252.
25. Kouchi, M. & Mochimaru, M. (2001). Development of a low cost foot-scanner for a custom shoe making system. In 5th ISB Footwear Biomechanics, pp. 58-59.
26. Krauss, I., Grau, S., Mauch, M., Maiwald, C. & Horstmann, T. (2008). Sex-related differences in foot shape. Ergonomics, 51(11), pp. 1693-1709.
27. Krauss, I., Langbein, C., Horstmann, T. & Grau, S. (2011). Sex-related differences in foot shape of adult Caucasians – a follow-up study focusing on long and short feet. Ergonomics, 54(3), pp. 294-300.
28. Luximon, A. & Goonetilleke, R.S. (2004). Foot shape modeling. Human Factors, 46(2), pp.304-315.
29. Luximon, A. (2001). Foot shape evaluation for footwear fitting. PhD Thesis, Department of Industrial Engineering and Engineering Management, Hong Kong University of Science and Technology.
30. Luximon, A. & Luximon, Y. (2009). Shoe-last Design Innovation for Better Shoe Fitting. Computers in Industry, 60(8), pp.621-628.
31. Mochimaru, M., Kouchi, M. & Dohi, M. (2000). Analysis of 3-D human foot forms using the Free Form Deformation method and its application in grading shoe lasts. Ergonomics, 43(9), pp.1301-1313.
32. National Footwear Research Institute, Chinese Shoe Size and Last Design, China Light Industry Press, Bei Jing, 1984.
33. Pivečka, J. & Laure, S. (1995). The Shoe Last: Practical Handbook for shoe Designers, Published by the International School of Modern Shoemaking.
34. Rodrigo, A.S., Goonetilleke, R.S. & Witana, C.P. (2012). Model based foot shape classification using 2D foot outlines. Digital Human Modeling in Product Design, 44(1), pp. 48-55.
35. Rossi, W.A. & Tenant, R. (1986). Professional shoe Fitting Manual. Published by the National Shoe Retailers Association for the Professional Shoe Fitters Society, New York.
36. Sambhav, K., Tandon, P. & Dhande, S.G.(2011). Computer Aided Design and Development of Customized Shoe Last. Computer Aided Design, 8(6), pp.819-826.
37. Wunderlich, R.E. & Cavanagh, P.R. (2001). Gender differences in adult foot shape: implications for shoe design. Medicine & Science in Sports & Exercise, 33(4), pp. 605-611.
38. Xiong, S., Zhao, J., Jiang, Z. & Dong, M. (2010). A computer-aided design system for foot-feature-based shoe last customization. The International Journal of Advanced Manufacturing Technology, 46(1), pp. 11-19.