簡易檢索 / 詳目顯示

回結果列表
研究生： 林柏皓
Lin, Po-Hao
論文名稱： Materials and Physical Properties of Topological Insulator Bi2Te3 Thin Films by Molecular Beam Epitaxy
分子束磊晶成長拓撲絕緣體碲化鉍之材料與物理性研究
指導教授： 郭瑞年
洪銘輝
Kwo, J. R.
口試委員: 郭瑞年
Kwo, J. R.
洪銘輝
Hong, M.
林登松
Lin, D
學位類別： 碩士
Master
系所名稱： 理學院 - 物理學系
Department of Physics
論文出版年： 2014
畢業學年度： 102
語文別： 英文
論文頁數： 70
中文關鍵詞： 拓撲絕緣體 、碲化鉍 、分子束磊晶 、熱電材料
相關次數： 點閱：2  下載：0 
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報

    • High quality topological insulator (TI) Bi2Te3 thin films were grown on Al2O3 (0001) and SrTiO3 (111) substrate by molecular beam epitaxy. During the deposition of Bi2Te3 on Al2O3 (0001) substrate, very sharp reflection high-energy electron diffraction (RHEED) pattern with clear Kikuchi lines was observed at growth temperature of 340°C. The surface morphology was analyzed by atomic force microscopic (AFM), and the size of triangular shaped domains is approaching to 2μm, due to a 2D layer by layer growth mechanism. The normal scans of a 4-circle x-ray diffraction indicated that the c-axis of the epitaxial film was full strain relaxed. We have employed x-ray photoemission spectroscopy (XPS) and synchrotron radiation angle-resolved photoemission spectroscopy (ARPES) to characterize the chemical composition and the electronic structure. The evolution of the band structure with chemical composition is suggesting that Te plays the roles of the donors in the intrinsic doping for this TI materials. Based on the Te/Bi composition ratio calculated from XPS analysis, the ARPES images is explained in following; the higher content of Te, the deeper of the Dirac points (DP) are buried below the Fermi level. Furthermore, the doping level may be tuned by the Te: Bi composition. In varying the Te/Bi flux ratio from 14 to 25, we found the lowest doping level was achieved when the flux ratio was held at 20, according to both ARPES and Hall measurements. On the other hand, high quality Bi2Te3 epilayer prepared on SrTiO3 (111) (STO) was achieved by introducing ~1 nm thick Bi2Se3 seed layer. The TEM image reveals a full epitaxial structure of Bi2Te3 film and Bi2Se3 seed layer down to the first quintuple layer. Furthermore, the crystallinity of the Bi2Te3 film and Bi2Se3 seed layer has been characterized by both RHEED and XRD. The in-plane lattice constant of the Bi2Se3 seed layer was found to be full strain relaxed. The in-plane crystallographic orientation for the Bi2Te3/Bi2Se3 on STO (111) layer-by-layer structure has been well studied and was found with following relationship: 〖[100]〗_(Bi_2 Te_3 )∥〖[110]〗_(Bi_2 Se_3 )∥〖[11 ̅0]〗_STO or 〖[110]〗_(Bi_2 Te_3 )∥〖[110]〗_(Bi_2 Te_3 )∥〖[11 ̅0]〗_STO. The diffraction pattern of Bi2Te3 film was found having an additional set of peaks due to deviation from the original growth orientation by 60° for Bi2Te3 (0 1 5), likely due to the formation of twin boundaries.

    Abstract iii Contents v List of Figures vii List of Tables xi Chapter 1 Theory and introduction 1 1.1 Introduction of topological insulator (TI) 1 1.2 Physical properties of Bi2Te3 6 Chapter 2 Instrumentations 10 2.1 In-situ deposition/characterization UHV system and molecular beam epitaxy 10 2.2 Reflection high energy electron diffraction (RHEED) 13 2.3 Atomic force microscope (AFM) 14 2.4 X-ray Diffraction (XRD) 16 2.5 Cs-corrected transmission electron microscopy (TEM) 17 2.6 Angle-resolved photoemission spectroscopy (ARPES) 18 2.7 X-ray photoemission spectroscopy (XPS) 20 2.8 Scanning Auger microscopy (SAM) 21 Chapter 3 Subject I (Material properties of high quality Bi2Te3/Al2O3 (001)) 25 3.1 Experimental procedure 25 3.2 Results and discussion I (Crystallinity) 27 3.2.1 In-situ RHEED analysis 27 3.2.2 X-ray diffraction 32 3.3 Results and discussion II (Surface morphology) 34 3.3.1 Surface morphology examined by AFM 34 3.4 Results and discussion III (Chemical composition and Electrical property) 42 3.4.1 X-ray photoemission spectroscopy 42 3.4.2 Angle-resolved photoemission spectroscopy 44 3.4.3 Electronic Property by Transport Measurement 46 3.5 Summery 49 Chapter 4 Subject II (High quality Bi2Te3 films on STO (111) by Bi2Se3 wetting layer method) 52 4.1 Introduction and experimental procedure 52 4.2 Results and discussion 54 4.2.1 In-situ RHEED analysis 54 4.2.2 In-plane x-ray diffraction 57 4.2.3 Cs-corrected transmission electron microscope (TEM) 59 4.3 Summery 60 References 62

    1. B. A. Bernevig, T. L. Hughes, and S. C. Zhang, Science 314 (5806), 1757 (2006).
    2. L. Fu, C. L. Kane, and E. J. Mele, Phys Rev Lett 98 (10), 106803 (2007).
    3. X.-L. Qi and S.-C. Zhang, Print edition 63 (1), 33 (2010).
    4. D. Hsieh, D. Qian, L. Wray, Y. Xia, Y. S. Hor, R. J. Cava, and M. Z. Hasan, Nature 452 (7190), 970 (2008).
    5. H. Zhang, C.-X. Liu, X.-L. Qi, X. Dai, Z. Fang, and S.-C. Zhang, Nat Phys 5 (6), 438 (2009).
    6. Y. P. Chen, 2012 (unpublished).
    7. C. J. Vineis, A. Shakouri, A. Majumdar, and M. G. Kanatzidis, Advanced Materials 22 (36), 3970 (2010).
    8. Y. L. Chen, J. G. Analytis, J. H. Chu, Z. K. Liu, S. K. Mo, X. L. Qi, H. J. Zhang, D. H. Lu, X. Dai, Z. Fang, S. C. Zhang, I. R. Fisher, Z. Hussain, and Z. X. Shen, Science 325 (5937), 178 (2009).
    9. S. O. Kasap and P. Capper, Springer handbook of electronic and photonic materials. (Springer, New York, 2006), pp.xxxii.
    10. S. E. Harrison, S. Li, Y. Huo, B. Zhou, Y. L. Chen, and J. S. Harris, Applied Physics Letters 102 (17) (2013).
    11. N. V. Tarakina, S. Schreyeck, T. Borzenko, C. Schumacher, G. Karczewski, K. Brunner, C. Gould, H. Buhmann, and L. W. Molenkamp, Crystal Growth & Design 12 (4), 1913 (2012).
    12. G. Zhang, H. Qin, J. Chen, X. He, L. Lu, Y. Li, and K. Wu, Advanced Functional Materials 21 (12), 2351 (2011).
    13. L. Fu and C. L. Kane, Physical Review Letters 100 (9), 096407 (2008).
    14. X.-L. Qi, R. Li, J. Zang, and S.-C. Zhang, Science 323 (5918), 1184 (2009).
    15. H. D. Li, Z. Y. Wang, X. Kan, X. Guo, H. T. He, Z. Wang, J. N. Wang, T. L. Wong, N. Wang, and M. H. Xie, New Journal of Physics 12 (10), 103038 (2010).
    16. W. Zhang, R. Yu, H.-J. Zhang, X. Dai, and Z. Fang, New Journal of Physics 12 (6), 065013 (2010).

    無法下載圖示 全文公開日期 本全文未授權公開 (校內網路)
    全文公開日期 本全文未授權公開 (校外網路)

    QR CODE